Nottepur SL160

Description

Polyurethane based, solvent free, two components, self levelling elastic glossy floor coating with high chemical abrasive strength and crack bridging feature.

Usage Areas

Concrete floors
Stores and offices
Cold storages
Schools and hospitals
Sports Flooring

Characteristics

Solvent-free.
Resistant against friction and abrasion.
Highly elastic structure.
Ensures joint-free, monolithic surface.
Easy to clean, Hygienic.
Does not require maintenance for a long time, & Easy to apply.

Application Method

The concrete floor must meet a minimum C25 standard, preferably C30-C35, and be clean and strong.
Prepare concrete surfaces to create a porous surface by removing cement grout.
Surface moisture should not exceed 4%, and application should not be done on concrete surfaces with rising humidity.
Ensure that application surfaces are sound, clean, free from dust, mold release agents, curing materials, bitumen, and other foreign substances.
Remove mortar and cement residues, and if possible, clean the surface by washing it with pressurized water and allowing it to dry.

Priming

Use NOTTEPOX P355 as the preferred primer for priming.
Apply the primer evenly on the surface using an appropriate brush, ensuring no ponding.
Once the primer is dry, proceed with the application.
If the surface humidity exceeds the standards, opt for NOTTEPOX P400 Humidity-Tolerant Primer.

Stir Component A in its container using a low-speed mixer (300-400 rpm) until it achieves homogeneity.
Add Component B into Component A and continue stirring for an additional 2 minutes to ensure overall homogeneity. Avoid overmixing to minimize air entrainment.
The prepared mixture should be used within a 40 minutes.

Avoid applying the product on surfaces exposed to prolonged sunlight, excessive heat, or freezing conditions.
The product should not be applied when the ambient temperature is outside the range of +5°C to +30°C.
Protect the application area from wind and direct sunlight.
Do not step on the surface after application until the surface has fully hardened.

Consumption

1.2 kg/m² for 1mm thickness

Packaging and Storage

24 kg Tin (Set: Component A: 20 kg + Component B: 4 kg).
The product has a shelf life of 12 months when stored in a cool, dry environment between +10°C and +25°C on wooden pallets. Use the opened material within 24 hours after application.
Protect the surface from direct water contact for 48 hours.
The actual consumption amount may vary depending on application conditions and surface characteristics.

Safety Precautions

No smoking, open flames, or inadequate ventilation during application.
Wear appropriate work attire, goggles, masks, and protective gloves as per safety regulations.
Rinse eyes with water if contacted and seek medical attention.
Refer to the Safety Data Sheet (SDS) for further handling information.

Technical Data

Technical Data	Specification
Color	White, Grey, Blue, Green, All Colors
Mixture Ratio	5/1 (Component A/Component B)
Pot Life (20°C)	25 minutes
Density (20°C)	1.60 g/cm³
Application Temperature	Between -5°C to +30°C
Step Over Time	16 hours
Full Cure	48 hours
Resistance Against Chemical and Mechanical Loads	7 days
Adhesive Strength to Concrete	≥ 2 N/mm²
Tensile Strength	≥ 50 N/mm²
Abrasion Resistance by Taber Abrader	70 mg/mm²
Hardness (Shore D/7 days)	83
Permeability to Water Vapor	Class 1
Capillary Water Absorption	≤ 0.5 kg/(m²·h0.5)
Permeability to CO2	≤ 50