Nottepur PVC
Description
- Dispersion adhesive with low filler content for thin application in interior areas.
- Ready to use, water based dispersion adhesive for use as a wet bond adhesive requiring only short open time and can also be used with double drop method for maximum immediate grab.
Usage Areas
- Homogeneous and heterogeneous PVC and cushioned vinyl floor coverings.
- Carpets, PVC, and latex backings.
- Lightweight needlepunch floorings.
- Prepared, level, and absorbent subfloors.
- Domestic and commercial locations.
Characteristics
- Aqueous polymer dispersion, mineral based fillers, preservation agents, fibers, additives, and water.
- Easy to apply with high coverage.
- Excellent grab.
- Short open time and long working time.
- High final strength.
- Good resistance to plasticizers.
- Solvent free.
- Suitable for use on warm water underfloor heating systems and suitable for cleaning with spray extraction systems.
Application Method
- The floor must be levelled and cleaned from materials which would impair adhesion on the surface.
- Thoroughly vacuum the surface then apply primer.
- Apply the adhesive evenly onto the floor using a suitable notched trowel and allow open time as appropriate for the quantity applied, climatic conditions, substrate absorbency, and type of covering.
- Lay in the covering, rub down over the whole surface and, after approx. 20 minutes, rub down with pressure or roll.
- Optimum working conditions: 18 – 25 °C, floor temperature above 15 °C
- Relative Humidity below 75%
- Low temperatures & high humidity lengthen the working, setting, and drying times.
- High temperatures & low humidity shorten the working, setting, and drying times.
- Leave until the adhesive is fully set (min. 24 hours but ideally 48 – 72 hours)
Consumption
Packaging and Storage
- Packaging: 20 kg bucket
- Shelf Life: Minimum shelf life 12 months in original packaging and in relatively cool storage conditions. Protect from frost. Tightly seal opened containers and use the contents as quickly as possible.
Safety Precautions
Contact of the product with the skin and eyes should be prevented, and in case of contact, it should be washed with plenty of water. If swallowed, drink a few glasses of water immediately and seek medical advice. In case of contact with eyes, they should be washed immediately with plenty of water and medical assistance should be obtained. Gloves and protective goggles should be used during use.
Technical Data
| Property | Value |
|---|---|
| Package | 6 kg & 20 kg plastic bucket |
| Shelf Life | min. 12 months |
| Colour | cream & white |
| Working Temperature | min. 5°C |
| Consumption | 0.300 – 0.400 g/m² |
| Open Time | 10 – 15 minutes* |
| Working Time | approx. 35 minutes* |
| Set to Traffic | after 24 – 48 hours* |
| Final Strength | after 3 – 4 days* |
Note: The values given assume typical conditions at +20°C and 50% relative humidity. High temperatures shorten the time, low temperatures prolong the time.
Application Areas
