Nottefoam 600

Description

The product is formulated for fixing and gap filling applications, offering an economical solution for gap filling applications. It is resistant to humidity and mould, and it provides a long life semi-hard filling material.

Usage Areas

Filling gaps around door and window frames.
Filling penetration gaps of gas pipes, plumbing, and electricity installations.
Filling holes, cracks, and gaps in buildings for insulation purposes.
Mounting applications of panels, air conditioning, and air vents.

Characteristics

Low expansion, does not apply high pressure on application substrates and door frames.
High yield enables to fill around a higher number of door and window frames.
Cures quite fast even eliminating the need of moisturizing the substrates.
Excellent cell structure and stability enables effective insulation and no shrinkage.
Semi-flexible structure enables to re-shape the foam by hand with ease.

Application Method

Application surfaces must be clean and dry and not contain oil, rust, and loose parts.
Slightly wetting the surfaces might increase performance of foam and make it dry faster.
The surrounding of application areas where foam shall not be applied may be covered for protection purposes.

Bring aerosol can to room temperature.
Ambient temperature should be +10°C to +30°C.
Shake the can vigorously before attaching the straw.
Attach the straw to the valve by twisting.
While the can is upside down, press the trigger for the foam to come out.
Since the foam would expand, fill the gaps partially.
Too big gaps should be filled in two layers and top of foam should be wetted.
Continue to shake the can from time to time during application.
Leave the straw for the next application, otherwise clean the valve with a solvent like acetone.
Fresh foam can be cleaned with foam cleaner or a solvent like acetone.

Consistency: non-sag
Application temperature: +5°C to +40°C
Set time (initial / for contact): minimum 20 minutes
Set time (formation of surface film): minimum 35 minutes

Consumption

Changes according to application type and surface.

Packaging and Storage

600g Aerosol cans, 16 cans in a box – Pipette Applied
It is stored in a cool and dry environment in an upright position between 10°C and 30°C.

Safety Precautions

To protect from direct sunlight, the foam must be painted or covered with a sealant.
It is not possible to provide strong adhesion on teflon, PE, and PP plastics.
It contains difenylmethane-4,4-diisocyanate. If inhaled for long periods, it may cause sensitivity on respiratory organs. If the wet foam contacts the skin for long periods, it may cause local rash and sensitivity on the skin.
The environment should be well-ventilated during the application, contact with the skin should be avoided and protective gloves and safety goggles should preferably be worn.
Aerosol can is filled with flammable propellant gases under high pressure. It should not be punctured and should be kept away from any heat source or flames.
Refer to safety info form of the product for detailed information.

Technical Data

Property	Value
Density	24-28 kg/m3
Yield	35-45 litres/1000ml
Fire Rate (DIN 4102)	B3
Shrinkage	Max 4%
Expansion	96150-250
Tack-Free Time	15-20 minutes
Cutting Time	1 hour
Full drying	12-24 hours
Color	Light Yellow
Thermal stability	between -50°C and +100°C
Compression strength	min 3 N/mm²
Thermal Conductivity	0.030 W/m K
Water Absorption	max. 2620
Flashpoint (cured foam)	>400°C