Nottefix GP 910
Description
Nottefix GP 910 is a multipurpose acetoxy cure silicone sealant that cures quickly to provide a permanently flexible, high-strength waterproof seal. It contains a powerful antifungicide to prevent mould growth.
Usage Areas
- Sealing glass to glass.
- Sealing glass to aluminum and metal.
- Sealing around baths, showers, basins, and other sanitary ware.
- Sealing around worktops and laminates.
- For aluminum gutter sealing.
Characteristics
- Permanently flexible.
- Anti-fungal formula & prevents mould growth.
- Quick curing & low dirt pick up.
- Low viscosity for fast application.
Application Method
- All surfaces must be clean, dry, and dust-free.
- All loose or flaking surface coatings, old sealant, and mastic joints should be removed before application.
- Glass, metal, and aluminium should be cleaned with a proprietary solvent cleaner prior to application for optimum adhesion.
Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed.
Smooth down within 10 minutes of application. To ensure a proper bond, always smooth the sealant down using a spatula or piece of wood wetted with a soap and water solution. An improved appearance can be achieved by placing masking tape to both sides of the joint and removing within 5 minutes of application.
Optimum working conditions 18°C – 25°C, floor temperature above 15°C, Relative Humidity below 75%.
Leave until the adhesive is fully set (min. 24 hours but ideally 48 – 72 hours).
Consumption
The approximate coverage amount may very depending on the application thickness: 10-12 linear meters / 330 gr cartridge.
Packaging and Storage
280 gr & 330gr Cartridges (25 cartridges in a box)
Store in cool dry conditions between + 5 ° C and 25 ° C Minimum shelf life 18 months in original packaging and in relatively cool storage conditions. Protect from frost. Tightly seal opened containers and use the contents as quickly as possible.
Safety Precautions
Contact of the product with the skin and eyes should be prevented, and in case of conta et, it should be washed with plenty of water. lf swallowed, drink a few glasses of water immediately and seek medical advice. in case of conta et with eyes, they should be washed immediately with plenty of water and medical assistance should be obtained. Gloves and protective goggles should be used during use.
Technical Data
| Property | Value |
|---|---|
| Skinning time | 5 mins @ 20°C |
| Cure time | 2 mm per 24 hours |
| Hardness (Shore A) | 15-25 |
| Shrinkage | 9-15% |
| Application Temp. Resistance | +5°C to +40°C |
| Service Temp. Resistance | -30°C to +150°C |
| Tensile strength | 1.5 MPa |
| Stress | 0.3MPa at 100% elongation |
| Specific gravity | 1.00 |
| Minimum joint width | 4 mm |
| Maximum joint width | 25 mm |
| Joint ratio | Maximum depth 50% of joint width |
| Elongation at break | 400% |
Note: The above values are given at +20°C and for 50% relative humidity. High temperatures shorten the time, low temperatures prolong the time.
Application Areas
