Nottefix 1KWR

Description

NOTTEFIX 1KWR is a one component, water-based silane/silox-an emulsion, a transparent protective coating and water repellent that penetrates well into the applied surface.

Usage Areas

Exterior facades,
Surfaces such as concrete, natural stone, brick, mortar,
It can be used in mineral-based structures such as roads, bridges, building exterior walls.

Characteristics

It provides waterproofing.
It penetrates very well into the structure it is applied to.
It does not form a film layer on the surface.
It does not change the appearance of the structure it is applied to.
It is resistant to U.V. rays & alkalies.
It increases the resistance of the structure it is applied to against chlorine and sulfates.
It is vapor permeable, does not prevent the surface from breathing.
It is compatible with coatings such as paint to be applied on it.
It is water-based and environmentally friendly.

Application Method

The surface to be applied should be free from dust, oil, paint, curing and other substances that are not related to the structure and prevent penetration with detergent, steam, compressed air or brush.
Cracks larger than 0,200 mm on the surface should be repaired.
During application, the surface may be dry or slightly damp, but there should be no wet stains.
The best result is achieved by application on dry and highly absorbent surfaces.

NOTTEFIX IKWR is ready to use material.
It can be applied by brush, roller or low pressure spray.
It works better on dry and absorbent surfaces.
It is applied 2 or 3 layers according to the absorption rate of the surface.
A maximum of 3–5 hours should be waited between the layers.
The applied surface should be protected against rain for 3 hours.
It should be waited for 5 hours for paint application.

Consumption

Depending on the absorbency of the surface: 0.100 – 0.600 kg/m²

Packaging and Storage

5-20-30 kg Plastic drum.
Shelf life when stored in its original packaging at +10°C / +30°C in dry, protected and ventilated environments, protected from sun, rain and frost, is 12 months from the date of manufacture.

Safety Precautions

During application and mixing, contact of the material with the skin and eyes should be prevented, and in case of contact, it should be washed with plenty of water. In case of contact with eyes, they should be washed immediately with plenty of water and medical assistance should be obtained. Gloves, protective clothing / mask / goggles should be used during use.